Directions:
Preparation:
- It is recommended that your vehicle is decontaminated and paint corrected before applying ExoForma Graphene Paint Coating. Any defects in the surface of your paint could be enhaced when applying a coating over them, so it is important to make sure your paint is in great condition before applying the coating, whether it just needs a light polish or a full paint correction.
- All waxes, sealants, or polishes must be removed completely from the surface of the vehicle to ensure that the coating is bonding directly to the surface of the paint or clear coat.
- Work in a dry, indoor environment when applying.
- Make sure the vehicle's surface is dry for 24 hours after application
Precautions:
- Do not apply in direct sunlight or on a hot surface.
- Do not reuse suede applicators or towels after using them to apply a coating. The coating will crystalize on them and could scratch paint if re-used.
- It is recommended to wear gloves and be in a well-ventilated area when applying.
- Be sure to work in small sections to avoid letting the product dry before having a chance to level it with a towel.
Directions:
1.) After polishing our vehicle, use our Prep Spray to make sure no oils are left from the polish.
2.) Shake the coating well and apply 7-8 drops to the suede applicator block. Ensure there are no dry spots on the applicator.
3.) Spread the product across the panel or 3'x3' area in a cross-hatch pattern to ensure complete coverage.
4.) Allow the product to flash (showing a rainbow appearance) on the surface and wait 3-5 minutes then wipe with a microfiber or plush towel thoroughly. The longer the coating is on the surface, the more it will become tacky and resist wiping with a towel. It is recommended to wait 3-5 minutes.
5.) Move to the next section and repeat the process until the vehicle is completely covered.
6.) Once finished, allow the vehicle to cure for at least 24 hours in an area where it won't be exposed to dust or water.
- It is recommended to wear gloves and be in a well-ventilated area when applying.
- Be sure to work in small sections to avoid letting the product dry before having a chance to level it with a towel.